sediment-core-extrusion-method-at-millimeter-resolution-using

Sediment Core Extrusion Method at Millimeter Resolution Using a Calibrated, Threaded-rod

Aquatic sediment core subsampling is commonly performed at cm or half-cm resolution. Depending on the sedimentation rate and depositional environment, ...

The determination of (14)C in aragonite (CaCO(3)) decomposed thermally to CO(2) using an yttrium-aluminum-garnet doped neodymium laser is reported. Laser decomposition accelerator mass spectrometry (LD-AMS) measurements reproduce AMS determinations of (14)C from the conventional reaction of aragonite with concentrated phosphoric acid. The lack of significant differences between these sets of measurements indicates that LD-AMS radiocarbon dating can overcome the significant fractionation that has been observed during stable isotope (C and O) laser decomposition analysis of different carbonate minerals. The laser regularly converted nearly 30% of material removed into CO(2) despite it being optimized for ablation, where laser energy breaks material apart rather than chemically altering it. These results illustrate promise for using laser decomposition on the front-end of AMS systems that directly measure CO(2) gas. The feasibility of such measurements depends on (1) the improvement of material removal and/or CO(2) generation efficiency of the laser decomposition system and (2) the ionization efficiency of AMS systems measuring continuously flowing CO(2).

Accelerator mass spectrometry 14C determination in CO2 produced from laser decomposition of aragonite.

The burgeoning field of 'clumped isotope' paleothermometry, which has broad applications in geosciences, depends almost entirely on measurements made on two types of mass spectrometer with the same ion source design. Demonstration that these measurements can be carried out on a retrofitted mass spectrometer with a different type of ion source is important to the growing community of geoscientists considering employing this technique.

Measurement of multiply substituted isotopologues ('clumped isotopes') of CO2 using a 5 kV compact isotope ratio mass spectrometer: performance, reference frame, and carbonate paleothermometry.

Degradation of oil contamination yields stabilized products by removing and transforming reactive and volatile compounds. In contaminated coastal environments, the processes of degradation are influenced by shoreline energy, which increases the surface area of the oil as well as exchange between oil, water, sediments, microbes, oxygen, and nutrients. Here, a ramped pyrolysis carbon isotope technique is employed to investigate thermochemical and isotopic changes in organic material from coastal environments contaminated with oil from the 2010 BP Deepwater Horizon oil spill. Oiled beach sediment, tar ball, and marsh samples were collected from a barrier island and a brackish marsh in southeast Louisiana over a period of 881 days. Stable carbon ((13)C) and radiocarbon ((14)C) isotopic data demonstrate a predominance of oil-derived carbon in the organic material. Ramped pyrolysis profiles indicate that the organic material was transformed into more stable forms. Our data indicate relative rates of stabilization in the following order, from fastest to slowest: high energy beach sediments > low energy beach sediments > marsh > tar balls. Oil was transformed most rapidly where shoreline energy and the rates of oil dispersion and exchange with water, sediments, microbes, oxygen, and nutrients were greatest. Still, isotope data reveal persistence of oil.

Varying relative degradation rates of oil in different forms and environments revealed by ramped pyrolysis.

Ramped pyrolysis (RP) targets distinct components of soil and sedimentary organic carbon based on their thermochemical stabilities and allows the determination of the full spectrum of radiocarbon ((14)C) ages present in a soil or sediment sample. Extending the method into realms where more precise ages are needed or where smaller samples need to be measured involves better understanding of the blank contamination associated with the method. Here, we use a compiled data set of RP measurements of samples of known age to evaluate the mass of the carbon blank and its associated (14)C signature, and to assess the performance of the RP system. We estimate blank contamination during RP using two methods, the modern-dead and the isotope dilution method. Our results indicate that during one complete RP run samples are contaminated by 8.8 ± 4.4 μg (time-dependent) of modern carbon (MC, fM ∼ 1) and 4.1 ± 5.5 μg (time-independent) of dead carbon (DC, fM ∼ 0). We find that the modern-dead method provides more accurate estimates of uncertainties in blank contamination; therefore, the isotope dilution method should be used with caution when the variability of the blank is high. Additionally, we show that RP can routinely produce accurate (14)C dates with precisions ∼100 (14)C years for materials deposited in the last 10,000 years and ∼300 (14)C years for carbon with (14)C ages of up to 20,000 years.

Blank corrections for ramped pyrolysis radiocarbon dating of sedimentary and soil organic carbon.

In 2010, the Deepwater Horizon accident released 4.6–6.0 × 10(11) grams or 4.1 to 4.6 million barrels of fossil petroleum derived carbon (petrocarbon) as oil into the Gulf of Mexico. Natural abundance radiocarbon measurements on surface sediment organic matter in a 2.4 × 10(10) m(2) deep-water region surrounding the spill site indicate the deposition of a fossil-carbon containing layer that included 1.6 to 2.6 × 10(10) grams of oil-derived carbon. This quantity represents between 0.5 to 9.1% of the released petrocarbon, with a best estimate of 3.0–4.9%. These values may be lower limit estimates of the fraction of the oil that was deposited on the seafloor because they focus on a limited mostly deep-water area of the Gulf, include a conservative estimate of thickness of the depositional layer, and use an average background or prespill radiocarbon value for sedimentary organic carbon that produces a conservative value. A similar approach using hopane tracer estimated that 4–31% of 2 million barrels of oil that stayed in the deep sea settled on the bottom. Converting that to a percentage of the total oil that entered into the environment (to which we normalized our estimate) converts this range to 1.8 to 14.4%. Although extrapolated over a larger area, our independent estimate produced similar values.

Using natural abundance radiocarbon to trace the flux of petrocarbon to the seafloor following the Deepwater Horizon oil spill.

Sediment samples collected from shelf, slope and interior basin of the northern Gulf of Mexico during 2011-2013, 1-3 years after the Deepwater Horizon (DWH) oil spill, were utilized to characterize PAH pollution history, in this region. Results indicate that the concentrations of surface ΣPAH43 and their accumulation rates vary between 44 and 160 ng g(-1) and 6-55 ng cm(-2) y(-1), respectively. ΣPAH43 concentration profiles, accumulation rates and Δ(14)C values are significantly altered only for the sediments in the immediate vicinity of the DWH wellhead. This shows that the impact of DWH oil input on deep-sea sediments was generally limited to the area close to the spill site. Further, the PAHs source diagnostic analyses suggest a noticeable change in PAHs composition from higher to lower molecular weight dominance which reflects a change in source of PAHs in the past three years, back to the background composition. Results indicate low to moderate levels of PAH pollution in this region at present, which are unlikely to cause adverse effects on benthic communities.

Article	Year
Accelerator mass spectrometry 14C determination in CO2 produced from laser decomposition of aragonite. Rapid communications in mass spectrometry : RCM\| PubMed ID: 18844243	2008
Measurement of multiply substituted isotopologues ('clumped isotopes') of CO2 using a 5 kV compact isotope ratio mass spectrometer: performance, reference frame, and carbonate paleothermomet... Rapid communications in mass spectrometry : RCM\| PubMed ID: 23857930	2013
Varying relative degradation rates of oil in different forms and environments revealed by ramped pyrolysis. Environmental science & technology\| PubMed ID: 25105342	2014
Blank corrections for ramped pyrolysis radiocarbon dating of sedimentary and soil organic carbon. Analytical chemistry\| PubMed ID: 25375178	2014
Using natural abundance radiocarbon to trace the flux of petrocarbon to the seafloor following the Deepwater Horizon oil spill. Environmental science & technology\| PubMed ID: 25494527	2015
Distributions and accumulation rates of polycyclic aromatic hydrocarbons in the northern Gulf of Mexico sediments. Environmental pollution (Barking, Essex : 1987)\| PubMed ID: 26895564	2016

Brad E. Rosenheim

Biography

JoVE Journal Publications

Other Publications